Do not sell or share my personal information
As described in our Privacy Policy, we collect personal information from your interactions with us and our website, including through cookies and similar technologies. We may also share this personal information with third parties, including advertising partners. We do this in order to show you ads on other websites that are more relevant to your interests and for other reasons outlined in our privacy policy.
Sharing of personal information for targeted advertising based on your interaction on different websites may be considered "sales", "sharing", or "targeted advertising" under certain U.S. state privacy laws. Depending on where you live, you may have the right to opt out of these activities. If you would like to exercise this opt-out right, please follow the instructions below.
If you visit our website with the Global Privacy Control opt-out preference signal enabled, depending on where you are, we will treat this as a request to opt-out of activity that may be considered a “sale” or “sharing” of personal information or other uses that may be considered targeted advertising for the device and browser you used to visit our website.
Removing Side Rails
1a) Remove Philip head screws from the top side rail retainers
1b) Slide side rail away from top retainer
1c) Test fit side mount to rail, adjusting set screws so they just touch and turn back 1/8 turn, rail should slide loosely back and forth
1c) - cont'd set screws should be slightly raised (almost flush) with the backside of the mount
Installing Side Mounts
2a) Tilt side mount into position with the two prongs fitting inside
2b) Hold side mount in place as you install the side rail. Adjust side rail to fit back into the original position
2c) Once side rail is fitted in place to the top retainer, tighten screw into side rail
** When installing Dual Side Mount Bracket both sides will have to be sequenced in unison
Adjust Side Mounts
3a) Move side mount to lowest position resting against the bottom edge
3b) Tighten set screws 1/2 to 3/4 full turn until the screws bite into aluminum rails, screws should recessed just below plastics edge
3c) After 1st mount is tightened in place and second mount is installed, place another tool box into the mounts and push up on
the second mount to ensure engagement, then tightened set screws
**When installing secondary mounts to the Rolling Tool Box, only one mount per side is used. You will have to repeat the steps described in 3c to ensure the lower mounts are engaged, then tighten set screws
